B&T RQD 9mm Tri-Lug HUB Suppressor Mount

This is the piece that turns a HUB compatible suppressor into a tri-lug quick detach can. It threads into the 1.375x24 HUB threads at the rear of the suppressor and tightens down with a spanner wrench, and from there the can twists on and off any B&T or HK spec tri-lug 9mm barrel in a couple of seconds.

The mount is built from titanium and stainless steel components, so it holds up to the heat and the repeated mounting cycles that kill softer hardware. If you want the assembly permanent, Rocksett or a similar thread locking compound will hold it in place. If you would rather move the can between mounting styles later, leave it wrench tight and swap as needed.