Guntec USA AR-308 Extended Takedown Pin Set

Standard AR takedown and pivot pins sit flush with the receiver, which means a punch or a cartridge rim to push them out. This set replaces both with pins that carry knurled knobs on the end, so the upper comes off the lower with fingers alone. That matters in the cold, in gloves, or anywhere a tool is not within reach.

Guntec machines the set from steel with a phosphate finish and sizes it for AR-308 and AR-10 pattern receivers, which use different pin dimensions than an AR-15. Front pivot and rear takedown pins are both included. The detents and springs already in the lower are reused, so installation is a straight swap on the bench.